Microtensile bond strength of total-etch and self-etching adhesives to caries-affected dentine (2003)
- Autores:
- Autor USP: CARVALHO, RICARDO MARINS DE - FOB
- Unidade: FOB
- DOI: 10.1016/s0300-5712(03)00088-5
- Assuntos: ADESIVOS DENTINÁRIOS; CÁRIE DENTÁRIA; DENTINA
- Idioma: Inglês
- Resumo: Objectives. To evaluate the microtensile bond strength of total-etch or self-etch adhesives to caries-affected versus normal dentine, and to correlate these bond strengths with DIAGNOdent laser fluorescence and Knoop microhardness (KH) measurements of the substrates. Methods. Extracted carious human molars were ground to expose flat surfaces where the caries lesion was surrounded by normal dentine. Surfaces were bonded with either Prime & Bond NT, Scotchbond 1, Clearfil SE Bond or Prompt L-Pop, according to manufacturers' recommendations. A crown was built up using resin composite (Tetric Ceram). After storage in water (37 'GRAUS'C, 24 h), teeth were vertically serially sectioned into 0.7 mm thick slabs and trimmed to yield 1 mm2 test area that contained either caries-affected or normal dentine. Samples were tested in tension in an Instron machine at 1 mm/min. The quality of the dentine just beneath each fractured specimen was measured by laser fluorescence and KH. Results. Total-etch adhesives yielded higher bond strengths than self-etching systems. Significantly lower results were obtained with Prompt L-Pop. All the adhesives attained higher strengths in normal than in caries-affected dentine, but the differences were only significant for Prime & Bond NT and Clearfil SE Bond. Higher laser fluorescence values and lower KH (p<0.001) were recorded in caries-affected dentine compared to normal dentine. Conclusions. The total-etch adhesives evaluatedproduced higher bond strengths to normal and caries-affected dentine than self-etching systems. Laser fluorescence measurements discriminated caries-affected dentine from normal dentine, and were strongly correlated with KH. However, laser fluorescence and KH did not permit high correlations with resin-dentine bond strengths in caries-affected dentine
- Imprenta:
- Fonte:
- Título do periódico: Journal of Dentistry
- ISSN: 0300-5712
- Volume/Número/Paginação/Ano: v. 31, n. 7, p. 469-477, Sept. 2003
- Este periódico é de assinatura
- Este artigo NÃO é de acesso aberto
- Cor do Acesso Aberto: closed
-
ABNT
CEBALLOS, Laura et al. Microtensile bond strength of total-etch and self-etching adhesives to caries-affected dentine. Journal of Dentistry, v. 31, n. 7, p. 469-477, 2003Tradução . . Disponível em: https://doi.org/10.1016/s0300-5712(03)00088-5. Acesso em: 19 abr. 2024. -
APA
Ceballos, L., Camejo, D. G., Fuentes, M. V., Osorio, R., Toledano, M., Carvalho, R. M. de, & Pashley, D. H. (2003). Microtensile bond strength of total-etch and self-etching adhesives to caries-affected dentine. Journal of Dentistry, 31( 7), 469-477. doi:10.1016/s0300-5712(03)00088-5 -
NLM
Ceballos L, Camejo DG, Fuentes MV, Osorio R, Toledano M, Carvalho RM de, Pashley DH. Microtensile bond strength of total-etch and self-etching adhesives to caries-affected dentine [Internet]. Journal of Dentistry. 2003 ; 31( 7): 469-477.[citado 2024 abr. 19 ] Available from: https://doi.org/10.1016/s0300-5712(03)00088-5 -
Vancouver
Ceballos L, Camejo DG, Fuentes MV, Osorio R, Toledano M, Carvalho RM de, Pashley DH. Microtensile bond strength of total-etch and self-etching adhesives to caries-affected dentine [Internet]. Journal of Dentistry. 2003 ; 31( 7): 469-477.[citado 2024 abr. 19 ] Available from: https://doi.org/10.1016/s0300-5712(03)00088-5 - Avaliação da longevidade da união a dentina: efeito da quantidade de umidade para adesivos com diferentes solventes
- Efeito da manipulação com luva em alguns materiais de moldagem
- Hema diffusion through wet versus dry demineralized dentin
- Bond strength as affected by HEMA concentration in rewetting solutions
- Effect of configuration and mode of cure on microleakage
- Tensile properties of demineralized dentin matrix after 48 months
- Solvent-induced expansion of dried-demineralized dentin matrix
- Effects of prism orientation on tensile strength of enamel
- Bond strength of clearfil liner bond 2v to dentin
- Mapping bond strengths to flat dentin surfaces
Informações sobre o DOI: 10.1016/s0300-5712(03)00088-5 (Fonte: oaDOI API)
Como citar
A citação é gerada automaticamente e pode não estar totalmente de acordo com as normas
